Warning

1. Usually the receiver and transmitter have been paired with each other in the factory.
   If not, please reprogram them.

2. Reset before you want to change the operating mode.

3. After reset, all the remote controls cannot work anymore.

4. Replace the battery in time when the remote transmitter voltage is low,
   to get stronger signal transmission.

5. Slightly stretch the antenna on the receiver for better signal reception.

6. The remote transmitter needs to have 2 or more buttons
   if you want to set up in latched mode.

7. Usually, we control lights using toggle mode.

Operating Mode

Toggle Mode

1. Press button "A", relay will turn on.

2. Press button "A" again, this relay will turn off.

How to program

1. Press the learning button (on the receiver) 2 times.
   Wait for 3 seconds.

2. Press one button on the remote control. Succeed.

Latched Mode

1. Press button "A", relay will turn on.

2. Press button "B", this relay will turn off.

How to program

1. Press the learning button (on the receiver) 3 times.
   Wait for 3 seconds.

2. Press button "A" on the remote control.
   Wait for 3 seconds.

3. Press button "B" on the remote control. Succeed.

Delay Mode
After pressing the wireless remote control switch button to turn on the light,
the light will automatically turn off after 5/10/15 minutes.

How to program

1. Press the learning button (on the receiver) 4/5/6 times.
   Wait for 3 seconds.

2. Press button "A" on the remote control. Succeed.

Reset
Press the learning button (on the receiver) 8 times.
The indicator LED on the receiver will flash several times and then turn off. Succeed.

Troubleshooting
If the receiver and transmitter cannot operate normally,
try to solve the problem by following the steps below:

1. Please check if the battery power is used up.
   The indicator LED on the remote transmitter does not light up or is dimly lit.

2. Please check if your receiver is wired correctly.
   It is important to make sure the wiring is correct.

3. Please check if there are any transmitters operating in the surrounding environment,
   as they may interfere with pairing.

4. Reprogram the receiver and transmitter.
   Usually this can solve a lot of problems.

5. If the problem still remains, please contact us in time.
   We will do our best to solve your problem.

   Email: samjingco@outlook.com
   WhatsApp: +86 15812381273